Recording Data
You can record measurement data and view it on the display of the DPL4000. To record data, do the following:
1. Press 
Record or open the menu and select Recording/Viewing.
2. Select Record data and press 
.
3. To change the recording interval, select Interval and press Set.
4. Select the measurement interval with the arrow buttons. The measurement intervals and the maximum recording times are shown in Table 1 Measurement Intervals and Maximum Recording Times on page 1.
Table 1 Measurement Intervals and Maximum Recording Times
|
Measurement Interval |
Maximum Recording Time (Memory Full) |
||
|---|---|---|---|
|
1 quantity |
2 quantity |
3 quantity |
|
|
1 s |
45 min |
22 min |
15 min |
|
5 s |
3 h |
113 min |
75 min |
|
15 s |
11 h |
5 h |
3 h |
|
30 s |
22 h |
11 h |
7 h |
|
1 min |
45 h |
22 h |
15 h |
|
5 min |
9 days |
4 days |
3 days |
|
15 min |
28 days |
14 days |
9 days |
|
30 min |
56 days |
28 days |
18 days |
|
1 h |
113 days |
56 days |
37 days |
|
3 h |
339 days |
169 days |
112 days |
|
12 h |
1359 days |
678 days |
451 days |
5. Press Select.
6. To set the duration of the recording, select Duration and then press Set. Select the duration with the arrow buttons and press Set.
7. To start recording, select Start/Stop recording, press Start. If you choose Memory full, you will see the maximum recording time on the display. You can also delete files to empty the memory. To accept the maximum recording time, press Start again.
8. You can switch off DPL4000 during recording to save the battery. A message will appear on the display to inform that recording will continue undisturbed even when the power is turned off. If the indicator is switched off during recording, the progress bar is shown on the display every 10 seconds (continuously if the charger is connected). The bar indicates the amount of recorded data.
|
CAUTION |
Do not disconnect the probe when the data recording is on, even if the indicator is turned off. This may cause loss of recorded data. |